Chestnut Brown Floral Marquetry Tile Code40645 300x300mm

This ceramic tile combines a chestnut-brown wood-effect field with a symmetrical white floral motif formed from curved leaves and a central four-petal bloom. The square border supports a framed marquetry-inspired layout when repeated. Wood and marquetry describe visual effects only; the product is ceramic rather than natural timber, wood veneer, handcrafted marquetry, or a solid wooden tile.

Each tile measures 300x300mm, and one pack contains eleven pieces. Based on the nominal dimensions, a pack covers approximately 0.99 square metres before waste. The final quantity should include allowances for site measurements, perimeter cuts, motif alignment, breakage, and spare pieces. Confirm the manufacturer’s stated coverage and ask the installer to calculate the complete requirement before ordering.

The tile is listed for both floor and wall use and may be considered for suitable residential or commercial interiors. Final suitability depends on its floor-use rating, expected traffic, substrate, moisture exposure, and installation conditions. Review the technical specifications before choosing it for kitchens, bathrooms, entrances, balconies, or demanding commercial floors, since its design and finish cannot confirm every application independently.

A carving matt finish alone does not establish slip resistance or confirm suitability for wet flooring. Before selecting this tile for bathrooms, utility areas, balconies, or other moisture-prone locations, verify its tested slip-resistance rating, surface profile, and recommended application. Waterproofing, drainage slopes, compatible adhesive, suitable grout, and professional installation should also be planned according to the expected water exposure.

Dry-position several tiles before installation to review how the chestnut-colored frames repeat and how the white floral motifs align. Maintain consistent orientation for a regular grid, or test planned rotations if another composition is intended. Establish reference lines, examine perimeter cuts, and confirm the manufacturer’s recommended grout-joint width before applying adhesive to the flat and correctly prepared substrate.

Install the tile over a flat, clean, stable, and correctly prepared substrate using an adhesive suitable for ceramic tiles, the receiving surface, and the intended application. Follow the manufacturer’s guidance for adhesive coverage, joint width, curing, and grouting. A qualified installer should monitor motif alignment and perimeter cuts while providing movement joints wherever required by project conditions and applicable installation standards.

Clean the installed surface using water, a soft mop or cloth, and a mild cleaner recommended for ceramic tiles and grout. Use a soft brush where necessary to remove residue from the surface detailing. Avoid strong acids, abrasive powders, metal scrubbers, and unsuitable sealers. Test unfamiliar cleaning products on a small, inconspicuous area before applying them across the complete surface.