White Green Marble Tile Code40601

This marble-look tile is manufactured from glazed vitrified material and has a glossy finish. Its decorative design combines a bright white field with bold emerald-green fractures and finer grey-green veins. The Calacatta, jade, and marble appearances are surface effects rather than natural stone or gemstone content. Installation products and preparation should follow the manufacturer’s guidance for the intended floor or wall application.

This tile is specified for both floor and wall applications. It can be considered for suitable living spaces, entrances, feature walls, reception areas, retail displays, and selected commercial interiors. Confirm Code40601’s documented rating for expected traffic, moisture exposure, exterior conditions, substrate requirements, and maintenance before selecting it for any particular residential or commercial floor or wall location.

The glossy finish reflects light and increases the visibility of the bold green fractures and finer veins against the white field. However, glossy terminology does not establish slip resistance or wet-floor safety. Before installation in bathrooms, kitchens, entrances, balconies, or other moisture-prone areas, verify documented slip-resistance information and suitability, together with appropriate waterproofing, drainage, slope, substrate preparation, adhesive, and grout.

The pattern presents a bright white background with bold emerald-green fractured sections and finer branching grey-green veins. Concentrated green movement contrasts with broader areas of open white. Lighting, reflections, viewing angle, grout color, screen settings, surrounding finishes, and production variation can influence the result, so inspect a current physical sample before ordering the required quantity.

Each tile measures 600x1200mm, and one pack contains two pieces. Together, the tiles provide approximately 1.44 square metres of nominal coverage before cuts and wastage. Measure the complete floor or wall area and include additional material for openings, perimeter trimming, vein distribution, accidental breakage, batch consistency, and spare pieces that may be required for future repairs or replacements.

Dry-lay several tiles before fixing them to review vein direction, green distribution, pattern continuity, joint width, and cut positions. Use an adhesive suitable for glazed vitrified tiles, the prepared substrate, and the intended application. A qualified installer should plan the starting point, perimeter cuts, transitions, movement joints, grout selection, coverage, and curing according to the manufacturer’s technical guidance.

Remove loose dust with a soft cloth, brush, or suitable vacuum, then clean the tile using water or a pH-neutral product recommended for glazed vitrified surfaces. Avoid abrasive pads, harsh acids, sharp tools, and untested chemicals that could scratch or dull the glossy finish. Test unfamiliar cleaners on a concealed section and remove residue according to the product manufacturer’s guidance.