Black Textured Wall Tile Code40042

This textured wall tile is manufactured from ceramic material and has a matt charcoal-black surface. Broad raised ribs create vertical relief, while bronze-toned accents outline selected edges and horizontal divisions. These accents are part of the visual design and do not mean the tile is made from bronze. Follow the manufacturer’s guidance for adhesive selection, substrate preparation, joint planning, and installation.

The tile can be considered for living-room features, kitchen backsplashes, vanity surrounds, bathroom wall sections, reception areas, cafés, restaurants, retail displays, and selected hospitality interiors. For walls exposed to regular water, confirm documented wet-wall suitability and complete the required waterproofing first. Substrate stability, adhesive selection, grout, movement joints, and installation quality also affect the finished performance.

No. This ceramic product is specified strictly for wall-only use and should not be installed as flooring. Its raised ribbed surface and matt wall classification do not establish the load, wear, impact, or slip performance required underfoot. Choose a separately rated coordinating floor tile and reserve this design for stable, level, and properly prepared vertical surfaces within suitable interior settings.

Each tile measures 300x600mm, and one pack contains six pieces. This provides approximately 1.08 square metres of nominal wall coverage before cuts and wastage. Measure the installation area carefully, then add extra material for openings, corners, trimming, rib alignment, accidental breakage, batch consistency, and spare tiles that may be needed for future repairs or replacements.

The surface appears charcoal black with warm bronze-toned detailing along the raised ribs and horizontal divisions. Its matt finish keeps reflections subdued while allowing the broad linear relief to remain visible. Lighting, surrounding colors, grout selection, screen settings, viewing angle, and production variation can influence its appearance, so inspect a current physical sample in the intended setting before ordering.

Install the tile over a clean, dry, stable, level, and suitably prepared wall using an adhesive appropriate for ceramic tiles and the intended application. A qualified installer should determine the starting point, joint width, corner treatment, cuts, and movement joints. Dry-lay the tiles first so the broad ribs, bronze-toned divisions, adjoining edges, and grout lines remain consistently aligned throughout the wall.

Remove loose dust from the raised ribs using a soft cloth or brush, then wipe the surface with clean water or a pH-neutral ceramic cleaner. Avoid abrasive pads, sharp tools, strong acids, and untested chemicals that could mark the matt surface or bronze-toned detailing. Test any unfamiliar cleaning product on a concealed section before applying it across the complete installed wall.