Black Onyx Tile Code40616

This onyx-look tile is manufactured from vitrified material and has a hi-gloss finish. Its decorative surface combines black, charcoal, and smoky grey layers with pale veins, fine white fractures, and occasional warmer accents. The onyx appearance is a surface effect rather than natural stone or translucent material. Installation products and preparation should follow the manufacturer’s guidance for the intended application.

This tile is specified for both floor and wall applications. It can be considered for suitable living spaces, entrances, feature walls, reception areas, retail displays, and selected commercial interiors. Confirm Code40616’s documented rating for expected traffic, moisture exposure, exterior conditions, substrate requirements, and maintenance before selecting it for any particular residential or commercial floor or wall location.

The hi-gloss finish produces strong reflections and increases the visibility of the smoky dark layers and pale veining. However, hi-gloss terminology does not establish slip resistance or wet-floor safety. Before installation in bathrooms, kitchens, entrances, balconies, or other moisture-prone areas, verify documented slip-resistance information and suitability, together with appropriate waterproofing, drainage, slope, substrate preparation, adhesive, and grout.

The design combines black, charcoal, and smoky grey layers with broad pale veins and fine white fractures. Translucent-looking clouded movement creates an onyx-inspired appearance, while occasional warmer accents add contrast. Lighting, reflections, viewing angle, grout color, screen settings, surrounding finishes, and production variation can influence the result, so inspect a current physical sample before ordering.

Each tile measures 600x1200mm, and one pack contains two pieces. Together, the tiles provide approximately 1.44 square metres of nominal coverage before cuts and wastage. Measure the complete floor or wall area and include additional material for openings, perimeter trimming, vein distribution, accidental breakage, batch consistency, and spare pieces that may be required for future repairs or replacements.

Dry-lay several tiles before fixing them to review vein direction, dark-tone distribution, pattern continuity, joint width, and cut positions. Use an adhesive suitable for vitrified tiles, the prepared substrate, and the intended application. A qualified installer should plan the starting point, perimeter cuts, transitions, movement joints, grout selection, coverage, and curing according to the manufacturer’s technical guidance.

Remove loose dust with a soft cloth, brush, or suitable vacuum, then clean the tile using water or a pH-neutral product recommended for vitrified surfaces. Avoid abrasive pads, harsh acids, sharp tools, and untested chemicals that could scratch or dull the hi-gloss finish. Test unfamiliar cleaners on a concealed section and remove residue according to the product manufacturer’s guidance.