White Black Carpet Tile Code40480A

This carpet tile is manufactured from vitrified material and has a matt finish. It is a hard-surface decorative tile rather than a soft textile or modular fabric carpet. Its corner design combines a large white rounded panel, black framing, double linear bands, and repeated semicircular petal motifs. Installation should follow the manufacturer’s technical guidance for the intended floor or wall application.

This tile is designed as a corner component within a coordinated carpet-style or framed layout. Its repeated petal border and parallel bands turn through a right angle around the larger rounded field. Before ordering, compare its size, colors, edge positions, and pattern direction with the intended border and feature tiles to confirm that all components create the planned arrangement.

The product is specified for both floor and wall applications. It can be considered for suitable entrance features, living-area floor accents, reception zones, retail displays, selected hospitality interiors, and decorative wall panels. Confirm the technical rating for expected traffic and conditions. Wet floors, outdoor areas, and demanding commercial applications require separately documented suitability before installation.

The matt finish limits strong reflections and keeps the black-and-white geometric pattern clearly defined. However, matt alone does not establish slip resistance or wet-floor safety. Before using the tile in bathrooms, entrances, kitchens, or moisture-prone areas, verify its documented slip-resistance rating and ensure appropriate substrate preparation, waterproofing where required, drainage, slope, grout selection, and professional installation.

Each tile measures 300x300mm, and one pack contains eight pieces. This provides approximately 0.72 square metres of nominal coverage before cuts and wastage. Since the product functions as a patterned corner component, calculate quantities from the complete modular layout rather than area alone. Include additional pieces for cuts, breakage, batch consistency, installation planning, and possible future replacement requirements.

Dry-lay the complete carpet-style arrangement before permanent fixing. Begin with the planned feature area, then position the border and corner components according to the approved layout. A qualified installer should check orientation, joint width, transitions, perimeter cuts, and movement joints so the petal forms, parallel bands, tile edges, grout lines, and adjoining patterns connect accurately across the finished design.

Remove loose dust using a soft cloth, brush, or suitable vacuum, then clean the tile with water or a pH-neutral cleaner intended for vitrified surfaces. Avoid abrasive pads, harsh acids, sharp tools, and untested chemicals that could mark the matt finish. Clean spills promptly and test unfamiliar products on a concealed section before applying them throughout the complete installation.