Black Full Body Vitrified Tile Code39963

This product is classified as a full-body vitrified tile with a low-reflection matt surface and a stated 15mm thickness. Its soot-black design carries fine tonal grains that create a restrained, nearly uniform appearance. Confirm the manufacturer’s technical information for load, traffic, water absorption, application, and installation requirements before specifying it for a particular residential or commercial setting.

The 15mm thickness must be considered when planning finished floor levels, transitions, thresholds, door clearances, adhesive-bed depth, cutting methods, equipment, and handling. It is a physical dimension rather than proof of a particular load or traffic rating. Confirm the supporting technical data and installation requirements before treating the thickness as suitable for demanding commercial, outdoor, or heavy-use conditions.

Listed for floor and wall applications, this tile can be considered for living spaces, kitchens, passages, offices, shops, commercial interiors, and feature walls. Before selecting it for bathrooms, entrances, balconies, exterior areas, or heavily used floors, verify its slip-resistance, wet-area, exterior-use, and traffic ratings. The 15mm thickness must also be coordinated with adjoining levels and finishes.

Each tile measures 600x600mm and is supplied with a stated 15mm thickness. One pack contains two pieces and provides approximately 0.72 square metres of nominal coverage before cuts and wastage. Use accurate site dimensions to calculate the quantity, then add an allowance for the laying pattern, trimming, breakage, batch consistency, and spare pieces for possible future replacement.

The tile has a deep soot-black to charcoal tone with fine grey grains distributed across the surface. Its matt finish limits strong reflections and creates a quiet, contemporary appearance without a prominent pattern. Lighting, grout color, nearby finishes, screen settings, and production batches can alter the perceived shade, so check a current physical sample under the intended lighting before ordering.

Professional installation is advisable because the 15mm thickness affects cutting, handling, finished levels, transitions, and adhesive-bed planning. Install over a clean, dry, stable, level, and correctly prepared substrate. A qualified installer should select the adhesive, trowel size, back-buttering method, joint width, movement joints, and cutting equipment according to manufacturer guidance, the substrate, intended use, and site conditions.

Remove loose dust and grit with a soft broom or vacuum before cleaning with water and a pH-neutral tile product. Avoid abrasive tools, strong acids, waxy coatings, and untested chemicals that could change the matt surface or grout. Attend to spills promptly, follow product instructions, and test any new cleaner on a concealed section before applying it across the installation.