Beige Textured Wall Tile Code40095

This textured wall tile is manufactured from ceramic material and has a glossy bisque-beige surface. Slim raised segments create linear relief, while cream and taupe markings provide a marble-style appearance. These markings are decorative and do not mean the tile is natural stone. Follow the manufacturer’s guidance for adhesive selection, substrate preparation, joint planning, and installation in the intended setting.

The tile can be considered for kitchen backsplashes, vanity surrounds, bathroom wall sections, living-room features, reception walls, cafés, restaurants, retail displays, and selected hospitality interiors. For walls exposed to regular water, confirm documented wet-wall suitability and complete the required waterproofing first. Substrate stability, adhesive selection, grout, movement joints, and installation quality also affect the finished performance.

No. This ceramic product is specified strictly for wall-only use and should not be installed as flooring. Its raised segmented surface and glossy wall classification do not establish the load, wear, impact, or slip performance required underfoot. Choose a separately rated coordinating floor tile and reserve this design for stable, level, and properly prepared vertical surfaces within suitable interior settings.

Each tile measures 300x600mm, and one pack contains six pieces. This provides approximately 1.08 square metres of nominal wall coverage before cuts and wastage. Measure the installation area carefully, then add extra material for openings, corners, trimming, segment alignment, accidental breakage, batch consistency, and spare tiles that may be needed for future repairs or replacements.

The surface has a warm bisque-beige base with cream and taupe marble-style markings. Slim vertical segments, rounded ends, and a glossy finish introduce depth and changing highlights. Lighting, surrounding colors, grout selection, screen settings, viewing angle, and production variation can influence the final appearance, so inspect a current physical sample in the intended setting before ordering.

Install the tile over a clean, dry, stable, level, and suitably prepared wall using an adhesive appropriate for ceramic tiles and the intended application. A qualified installer should determine the starting point, joint width, corner treatment, cuts, and movement joints. Dry-lay the tiles first so the raised segments, printed markings, adjoining edges, and grout lines remain consistently aligned throughout the wall.

Remove loose dust from the raised segments using a soft cloth or brush, then wipe the surface with clean water or a pH-neutral ceramic cleaner. Avoid abrasive pads, sharp tools, strong acids, and untested chemicals that could scratch the glossy surface or affect the printed details. Test unfamiliar cleaning products on a concealed section before applying them across the complete installed wall.