Grey Textured Wall Tile Code40031

This textured wall tile is made from ceramic material and finished with a glossy surface. Its winter-grey color is arranged across repeating elongated raised segments, giving the wall visible relief and light reflection. Because it is specifically classified for wall use, its installation products, substrate preparation, and layout should follow the manufacturer’s guidance for ceramic wall tiles and the intended room.

The tile can be considered for interior feature walls, living-room accents, kitchen backsplashes, vanity areas, bathroom wall sections, reception walls, and selected commercial interiors. For locations exposed to regular water, confirm the documented wet-wall suitability and prepare the substrate with the required waterproofing system. Final suitability depends on the wall condition, adhesive, grout, joints, and installation quality.

No. This product is specified for wall-only use and should not be installed on floors. Its textured ceramic surface and wall classification do not establish the load, wear, impact, or slip performance required for flooring. Use it only on suitably prepared vertical surfaces and select a separately rated floor tile for coordinating floor areas within the same room.

Each tile measures 300x600mm, and six pieces are supplied in one pack. The pack provides approximately 1.08 square metres of nominal wall coverage before cutting and wastage. Calculate the quantity from accurate wall measurements and include an allowance for corners, openings, edge cuts, pattern alignment, breakage, batch consistency, and spare tiles for potential future repairs.

The design combines a pale winter-grey tone with repeating elongated segments arranged in horizontal rows. Raised edges create visible relief, while the glossy finish reflects light and makes the pattern more pronounced from certain angles. Lighting temperature, grout color, viewing direction, screen settings, and batch variation can affect its appearance, so review a current physical sample before final selection.

Install the tile on a clean, dry, level, stable, and correctly prepared wall using an adhesive suitable for ceramic tiles and the application area. A qualified installer should plan the starting point, joint width, corner treatment, cuts, and movement joints. Dry-lay the arrangement first so the raised segments and grout lines remain consistently aligned across adjoining tiles.

Remove loose dust with a soft cloth, then wipe the tile using clean water or a pH-neutral cleaner suitable for ceramic surfaces. Avoid abrasive pads, harsh acids, metal tools, and untested chemicals that could scratch or dull the glossy finish. Clean grout lines separately when required and test unfamiliar products on a concealed area before treating the full wall.