Black Textured Wall Tile Code40029

This textured wall tile is manufactured from ceramic material and has a glossy black surface. Its design consists of elongated raised segments with rounded ends arranged across repeating horizontal rows. Since the product is specifically classified for walls, adhesive selection, substrate preparation, grout planning, and installation should follow the manufacturer’s ceramic wall-tile guidance and the requirements of the intended interior location.

The tile can be considered for kitchen backsplashes, vanity surrounds, bathroom wall sections, living-room features, reception walls, restaurants, cafés, retail displays, and other selected interior vertical surfaces. For walls exposed to frequent water, confirm the documented wet-wall suitability and complete the necessary waterproofing first. Wall stability, adhesive, grout, movement joints, and installation quality also influence the finished performance.

No. This product is specified for wall-only use and should not be installed as flooring. Its ceramic body, raised segmented design, and glossy wall classification do not establish the load, wear, impact, or slip performance required for floors. Select a separately rated coordinating floor tile and apply this pattern only to stable, level, and properly prepared vertical surfaces.

Each ceramic tile measures 300x600mm, and one pack contains six pieces. This provides approximately 1.08 square metres of nominal wall coverage before cuts and wastage. Calculate the required quantity from accurate wall measurements, then allow for openings, corners, trimming, segment alignment, breakage, batch consistency, and spare tiles that may be required for future repairs.

The surface has a deep pitch-black tone arranged across elongated vertical segments. Rounded ends and raised edges produce structured relief, while the glossy finish creates bright directional highlights over the dark surface. Lighting, surrounding colors, grout choice, screen settings, viewing angle, reflections, and batch variation may affect its appearance, so inspect a current physical sample before ordering.

Install the tile over a clean, dry, stable, level, and suitably prepared wall using an adhesive intended for ceramic tiles and the application area. A qualified installer should determine the starting point, joint width, corner treatment, cuts, and movement joints. Dry-lay the panels first so the elongated segments, raised edges, and grout lines align consistently across neighbouring tiles.

Remove loose dust from the raised sections using a soft cloth or brush before wiping the tile with clean water or a pH-neutral ceramic cleaner. Avoid abrasive pads, sharp tools, harsh acids, and untested chemicals that could scratch or dull the glossy black surface. Test unfamiliar products on a concealed section before applying them throughout the complete installed wall.