Green Textured Wall Tile Code40034

This textured wall tile is manufactured from ceramic material and finished with a glossy kelp-green surface. Its design features elongated raised segments with rounded ends, arranged in four repeating horizontal rows. Because it is specifically classified for walls, the adhesive, substrate preparation, joint planning, and installation method should follow the manufacturer’s ceramic wall-tile instructions and the requirements of the chosen interior setting.

The tile can be considered for kitchen backsplashes, vanity surrounds, bathroom wall sections, living-room features, reception walls, cafés, restaurants, retail displays, and other selected interior vertical surfaces. For areas exposed to regular water, confirm its documented wet-wall suitability and complete the necessary waterproofing first. Substrate stability, adhesive selection, grout, movement joints, and installation quality also influence finished performance.

No. This ceramic product is specified strictly for wall-only use and should not be installed as flooring. Its raised segmented texture and glossy wall classification do not establish the load, wear, impact, or slip performance needed underfoot. Choose a separately rated coordinating floor tile and reserve this design for stable, level, and properly prepared vertical surfaces within suitable interior areas.

Each tile measures 300x600mm, and one pack contains six pieces. This provides approximately 1.08 square metres of nominal wall coverage before cuts and wastage. Measure the installation area carefully, then include extra material for openings, corners, trimming, alignment, accidental breakage, batch consistency, and spare tiles that may be useful if future repairs or replacements become necessary.

The surface presents a muted kelp-green tone with olive undertones across elongated vertical segments. Rounded ends and raised edges introduce linear depth, while the glossy finish produces directional highlights and reflections. Lighting temperature, surrounding colors, grout selection, screen settings, viewing angle, and production variation can influence its appearance, so inspect a current physical sample in the intended setting before ordering.

Install the tile over a clean, dry, stable, level, and suitably prepared wall using an adhesive appropriate for ceramic tiles and the application area. A qualified installer should determine the starting point, joint width, corner treatment, cuts, and movement joints. Dry-lay the tiles first so their raised segments, row divisions, adjoining edges, and grout lines remain consistently aligned throughout the wall.

Remove loose dust from the raised segments using a soft cloth or brush, then wipe the surface with clean water or a pH-neutral ceramic cleaner. Avoid abrasive pads, sharp tools, strong acids, and untested chemicals that may scratch or dull the glossy green finish. Test any unfamiliar cleaning product on a concealed section before applying it across the complete installed wall.