Grey Textured Wall Tile Code40038

This textured wall tile is manufactured from ceramic material and finished with a glossy bone-grey surface. Its design features slim raised segments with rounded ends and subtly uneven faces, arranged in four horizontal rows. As the product is classified for walls, adhesive selection, substrate preparation, joint planning, and installation should follow the manufacturer’s ceramic wall-tile instructions and the intended interior setting.

The tile can be considered for kitchen backsplashes, vanity surrounds, bathroom wall sections, living-room features, reception walls, cafés, restaurants, retail displays, and other selected interior vertical surfaces. For areas exposed to regular water, confirm documented wet-wall suitability and complete the necessary waterproofing first. Substrate stability, adhesive selection, grout, movement joints, and installation quality also affect finished performance.

No. This ceramic product is specified strictly for wall-only use and should not be installed as flooring. Its raised segmented surface and glossy wall classification do not establish the load, wear, impact, or slip performance needed underfoot. Select a separately rated coordinating floor tile and reserve this design for stable, level, and properly prepared vertical surfaces in suitable interior settings.

Each tile measures 300x600mm, and one pack contains six pieces. This provides approximately 1.08 square metres of nominal wall coverage before cuts and wastage. Measure the installation area carefully, then include extra material for openings, corners, trimming, segment alignment, accidental breakage, batch consistency, and spare tiles that may be useful for future repairs or replacements.

The surface combines a light bone-grey color with slight tonal variation across slim vertical segments. Gently rounded ends and subtly uneven faces introduce visual depth, while the glossy finish creates changing highlights. Lighting temperature, surrounding colors, grout selection, screen settings, viewing angle, and batch variation can affect the appearance, so inspect a current physical sample before ordering.

Install the tile over a clean, dry, stable, level, and suitably prepared wall using an adhesive appropriate for ceramic tiles and the intended application. A qualified installer should determine the starting point, joint width, corner treatment, cuts, and movement joints. Dry-lay the tiles first so the slim segments, horizontal divisions, adjoining edges, and grout lines remain consistently aligned throughout the wall.

Remove loose dust from the raised segments using a soft cloth or brush, then wipe the surface with clean water or a pH-neutral ceramic cleaner. Avoid abrasive pads, sharp tools, strong acids, and untested chemicals that may scratch or dull the glossy grey finish. Test any unfamiliar cleaning product on a concealed section before applying it across the complete installed wall.