Grey Textured Wall Tile Code40053

This textured wall tile is manufactured from ceramic material and has a matt dusk-grey surface. Slim raised segments with softly rounded ends create a structured linear appearance across four horizontal rows. Since the product is specifically classified for walls, adhesive selection, substrate preparation, joint planning, and installation should follow the manufacturer’s ceramic wall-tile guidance and the requirements of the intended interior setting.

The tile can be considered for living-room features, kitchen backsplashes, vanity surrounds, bathroom wall sections, reception areas, cafés, restaurants, retail displays, and selected hospitality interiors. For walls exposed to regular water, confirm documented wet-wall suitability and complete the required waterproofing first. Substrate stability, adhesive selection, grout, movement joints, and installation quality also affect the finished performance.

No. This ceramic product is specified strictly for wall-only use and should not be installed as flooring. Its raised segmented surface and matt wall classification do not establish the load, wear, impact, or slip performance required underfoot. Choose a separately rated coordinating floor tile and reserve this design for stable, level, and properly prepared vertical surfaces within suitable interior settings.

Each tile measures 300x600mm, and one pack contains six pieces. This provides approximately 1.08 square metres of nominal wall coverage before cuts and wastage. Measure the installation area carefully, then add extra material for openings, corners, trimming, segment alignment, accidental breakage, batch consistency, and spare tiles that may be needed for future repairs or replacements.

The surface has a muted dusk-grey tone with subtle variation across its slim vertical segments. Rounded ends and gentle relief give the pattern definition, while the matt finish limits strong reflections. Lighting temperature, surrounding colors, grout selection, screen settings, viewing angle, and production variation can affect its appearance, so inspect a current physical sample in the intended setting before ordering.

Install the tile over a clean, dry, stable, level, and suitably prepared wall using an adhesive appropriate for ceramic tiles and the intended application. A qualified installer should determine the starting point, joint width, corner treatment, cuts, and movement joints. Dry-lay the tiles first so the raised segments, horizontal divisions, adjoining edges, and grout lines remain consistently aligned throughout the wall.

Remove loose dust from the raised segments using a soft cloth or brush, then wipe the surface with clean water or a pH-neutral ceramic cleaner. Avoid abrasive pads, sharp tools, strong acids, and untested chemicals that could mark or alter the matt grey finish. Test any unfamiliar cleaning product on a concealed section before applying it across the complete installed wall.